Problems with a Scantronic 9448+ and bell

[Kingbroady]

Hi.

I've just installed a new Scanny 9448+ in my house however when I go into engineer mode 3 lights come on three zones. From this I assume that there is a problem so am happy to link them out. How do I do this, please?

Also, the new bell is not sounding. It was, but is no longer. Maybe a blown
fuse?

Any help appreciated.

Thanks.

[Rem Alarms]

I'd check all fuses before you do anything else. Are sensors lighting up?
To link out zones, remove wiring & replace with a staple or short length of wire.
Ron.