Well... This is what you guys have been waiting for. I received my Era Designs Trigger today! I have not used the trigger in game yet! but i will be doing so this weekend! I will update this post once I do so.

Upon opening the package first thing i noticed was how nice/ sleek this trigger looked. Era's pictures do not do the JUSTICE!

Installation was a breeze! I guess some of the stock pins needed to be sanded, so they would fit in the roller bearing.

Mine fit perfect! Very snug! No wobble between the bearing and Pin what so ever!

Now I noticed a bit of side to side play, when just installing the trigger pin into the frame!

• This was not caused by the trigger, The roller bearing fits VERY snug on the trigger pin!
• Its actually caused by the holes in the frame being a lil on the biggish side for the trigger pin, thus causing the side to side play!
• what i did was applied little pieces of cotton to both sides of the trigger pin! This cut the side to side play down to pretty much NOTHING! A guide on how to do the following can be found HERE

Once my frame was back together, I had adjusted the trigger to my liking. And shot a few pods of Re-balls though my marker.

• The Feel is Just Amazing.
• Its Very Light.
• Lightning Fast.
• Very responsive.
• I don't even think there is a word for how smooth this trigger feels.
• The nylon tiped screws are great! Cuts down on the noise/ wear the stock trigger would make.
• Shape wise Id have to say the Era is a lil nicer then my pro trigger. It sits further back in the frame, which gives me more finger room in the trigger guard.
• I noticed the consistency as well as the speed of my walking was improved!

Since i have not tested this trigger while in game! I have to keep this review limited!

Overall, I am very impressed with this trigger. so far! I have yet to find any flaws that need to be addressed! Besides the side to side play, But again. This is not caused by the trigger in anyway! It is in fact the holes in the marker frame that cause the side to side play!

Era Designs is currently in the middle of getting a new pin machined, so this problem will not occur with production models! They also decided to implement flanged ball bearings into the trigger. So the final version will be slightly different than the one I have, but nothing major.

Now on to some pictures!